Modes Glas – Measurement
S – total width
Do you have any questions? Need help?Call us +48 518 075 074
Modes Glas Terrace Roofing – Measurement and Technical Data
Height of the Roofing
H – height at the wall H1 – 250cm standard (height of front supports)
The installation height at the wall (H) depends on the projection and the height of the front supports.
The recommended tilt angle is 8°
Below is a table of dimensions for the most commonly chosen heights:
| Projection (W) | Height of supports (H1) | Height at the wall (H) |
| 2,5m | 2200mm | 2698mm |
| 2,5m | 2500mm | standard 2998mm |
| 3m | 2200mm | 2768mm |
| 3m | 2500mm | standard 3068mm |
| Projection (W) |
Height of supports (H1) |
Height at the wall (H) |
| 3,5m | 2200mm | 2838mm |
| 3,5m | 2500mm | standard 3138mm |
| 4m | 2200mm | 2908mm |
| 4m | 2500mm | standard 3208mm |
Modes Glas Terrace Roofing – Technical Data
Roofing Gutter
• Front gutter 145.5×118.67mm
A baffle with dimensions 9.78x91x98mm is attached to the gutter.
The weight of the gutter with the baffle is approximately ~5.5kg/m.
Cross-section of the support and roofing gutter:
• Support/Column 140x120mm
• Rafter 55×111.3mm
Profiles of the starter strip and gutter finishing:
• Starter strip 42.85×156.54mm
• Front finish of the gutter 20.9x180mm
To install supports:
To ensure proper water drainage from the roofing, it is necessary to create a hole with a diameter of ⌀40mm in the lower part of the column or insert a pipe with a diameter of ⌀80-100mm. Then, finish the drainage with an elbow directing water outside.
For fastening the supports, use screws of size 4.8x22mm. Additional installation details for the roofing can be found on a separate webpage
Elements for support installation:
• Support base
• Support fastening
Comparison of the installation of polycarbonate and glass panels:
• Polycarbonate panels are available in thicknesses of 10mm and 16mm.
• Glass panels are available in a thickness of 8mm