Modes Terrace Roofing – Measurement and Technical Data

Modes – Measurement

S – total width
W – total projection

Height of the Roofing

H – height at the wall H1 – 250cm standard (height of front supports)

The installation height at the wall (H) depends on the projection and the height of the front supports.

The recommended tilt angle is 8°

Below is a table of dimensions for the most commonly chosen heights:

Roofing Gutter

• Front gutter 145.5×118.67mm

A baffle with dimensions 9.78x91x98mm is attached to the gutter.

The weight of the gutter with the baffle is approximately ~5.5kg/m.

Cross-section of the support and roofing gutter:

• Support/Column 140x120mm

• Rafter 55×111.3mm

Profiles of the starter strip and gutter finishing:

• Starter strip 42.85×156.54mm

• Front finish of the gutter 20.9x180mm

To install supports:

To ensure proper water drainage from the roofing, it is necessary to create a hole with a diameter of ⌀40mm in the lower part of the column or insert a pipe with a diameter of ⌀80-100mm. Then, finish the drainage with an elbow directing water outside.

For fastening the supports, use screws of size 4.8x22mm. Additional installation details for the roofing can be found on a separate webpage

Elements for support installation:

• Support base

• Support fastening

Comparison of the installation of polycarbonate and glass panels:

• Polycarbonate panels are available in thicknesses of 10mm and 16mm.

• Glass panels are available in a thickness of 8mm

Polycarbonate finishes:

• Rear finish 35x25mm

• Front finish 19.9x25mm